Exploded View - Selector Mechanism - Audi A8 2003 Workshop Manual

– Carefully lever out retaining tabs -arrows A- and -arrows B-
(retaining tabs are concealed).
– Detach guide and sliding cover together with tiptronic switch -
F189- from frame.
Note
Printed circuit -1- can only be renewed together with frame.
♦
Magnet for tiptronic switch -F189- can only be renewed to‐
♦
gether with sliding cover.
Guide must be renewed if retaining tabs are damaged.
♦
Installing
Installation is carried out in reverse sequence; note the following:
– Install selector mechanism cover
4.5

Exploded view - selector mechanism

1 - Rubber sleeve for selector
lever cable
❑ Check that rubber
sleeve for selector lever
cable is correctly attach‐
ed and make sure it
seals it off properly
2 - Locking plate
❑ For securing selector
lever cable to shift unit
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
❑ Installation position: an‐
with respect to the correctness of information in this document. Copyright by AUDI AG.
gled end points upwards
3 - Selector lever cable
❑ Do not bend or kink
❑ Selector lever cable
must be renewed if rub‐
ber sleeve is damaged
❑ Removing and installing
⇒ page 28
❑ Before installing, lightly
lubricate ball socket with
polycarbamide grease -
G 052 142 A2- .
❑ When installing, make
sure that rubber sleeve
on gearbox end is not
twisted
❑ Adjusting ⇒ page 33
4 - Bracket
❑ With rocker mechanism
for manual release
❑ Different versions (ac‐
cording to model) ⇒
Electronic parts cata‐
logue
multitronic 01J, front-wheel drive - Edition 11.2007
⇒ page 17 .
Audi A8 2003 ➤
4. Servicing selector mechanism
19