Audi A8 2003 Workshop Manual page 84

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
– Release quick-release fasteners -1- and -2- and detach noise
insulation panels.
– Place used oil collection and extraction unit -V.A.G 1782- be‐
low gearbox.
– If applicable, first remove additional ATF filter
– Remove bolts -2- and -4- and detach ATF pipes from addi‐
tional ATF cooler -A-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Clamp off cooling pipes -1- and -3- with hose clamps -3094-
with respect to the correctness of information in this document. Copyright by AUDI AG.
and remove from additional ATF cooler.
– Unscrew bolts -3- (4 x) and remove additional ATF cooler.
Installing
Installation is carried out in reverse sequence; note the following:
– Renew O-rings on ATF pipes leading to additional ATF cooler.
– Check ATF level ⇒ page 65
– Check coolant level.
Tightening torques
Component
Additional ATF cooler -A- to bracket -B-
4 x bolt -3-
ATF pipes to additional ATF cooler -A-
80
Rep. Gr.37 - Controls, housing
.
Nm
5
5