Audi A8 2003 Workshop Manual page 36

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
Note
Do not bend or kink the selector lever cable.
– Remove rubber sleeve -2- from selector mechanism.
– Remove retaining clip for selector lever cable (already re‐
leased in an earlier step).
– Detach selector lever cable -1- downwards out of shift unit.
– Apply lifting column of engine and gearbox jack -V.A.G 1383
A- to gearbox from below (place a block of wood -1- between
lifting column and gearbox).
– Use engine and gearbox jack to lift gearbox up slightly.
– First remove bolts -2- and -3- and then subframe securing
bolts -1- and -4-.
– Using engine and gearbox jack -V.A.G 1383 A- , lower gearbox
far enough to be able to access selector lever cable at selector
shaft lever at top of gearbox.
32
Rep. Gr.37 - Controls, housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.