Audi A8 2003 Workshop Manual page 83

♦ Hose clamps, up to Ø 25 mm -3094-
♦ Used oil collection and extraction unit -V.A.G 1782-
Removing
Note
Rules for cleanliness when working on the automatic gearbox
♦
⇒ page 9 .
General repair instructions
♦
Before fitting a new gearbox, always blow through the ATF
♦
cooler and ATF pipes with compressed air (not more than
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
10 bar) ⇒ page 75 and renew the additional ATF filter. If the
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
ATF which emerges during cleaning is very dirty, the pipes and
with respect to the correctness of information in this document. Copyright by AUDI AG.
ATF cooler must additionally be flushed out with clean ATF.
To install, first press ATF pipes onto gearbox or cooler by hand
♦
until they engage, then bolt on.
– If applicable, activate jacking mode when raising the vehicle
⇒ Running gear, front-wheel drive and four-wheel drive; Rep.
Gr. 43 ; Adaptive air suspension .
– Raise vehicle.
– On vehicles fitted with auxiliary heater, remove screws
-arrows- securing exhaust pipe of auxiliary/ additional heater
to noise insulation.
multitronic 01J, front-wheel drive - Edition 11.2007
⇒ page 7 .
10. Servicing ATF cooling system on vehicles with 3.0 ltr. MPI engine
Audi A8 2003 ➤
79