Removing And Installing Mounting Plate For Oil Cooler, Pressure Control Valve And Oil Filter; Housing - Audi Q7 2007 Workshop Manual

更多资料请访问深度汽车论坛 http://shenduauto.com/ 客服QQ：1398556747 电话：18218750259
–
Remove exhaust gas recirculation cooler
–
Detach crankcase breather hose -arrow- from pressure
control valve.
–
Unscrew bolts -1- and -2- and remove pressure control
valve for crankcase breather system.
Installing
Installation is carried out in the reverse order; note the follow-
ing:
Note
Renew O-rings.
♦
Secure all hose connections with the correct type of hose
♦
clips (same as original equipment) ⇒ Parts catalogue.
–
Install exhaust gas recirculation cooler
–
Install coolant pipe (rear)
–
Install bottom section of intake manifold (left and right)
⇒ Rep. Gr. 23.
–
Install intake manifold (top section) ⇒ Rep. Gr. 23.
–
Fill cooling system
Tightening torque
Component
Pressure control valve for crankcase breath-
er system to mounting plate
1.10 Removing and installing mounting plate for
oil cooler, pressure control valve and oil fil-
ter housing
Removing
–
Drain off coolant ⇒ page
–
Remove intake manifold (top section) ⇒ Rep. Gr. 23.
–
Remove bottom section of intake manifold (left and right)
⇒ Rep. Gr. 23.
–
Remove coolant pipe (rear)
–
Remove toothed belt for high-pressure pump
–
Remove high-pressure pump ⇒ Rep. Gr. 23.
–
Remove exhaust gas recirculation cooler
6-cylinder TDI engine (3.0 ltr. 4-valve common rail), mechanics 01.2006
⇒ page
⇒ page
181.
⇒ page
162.
161.
⇒ page 181.
1 Removing and installing parts of lubrication system
⇒ page 221.
221.
Nm
9
⇒ page
48.
⇒ page
221.
Audi Q7 2007 !
6
153