Audi A8 2003 Workshop Manual page 113

– Carefully install differential -arrow-.
– Fit cover for front final drive onto gearbox housing.
– Renew all bolts in cover for front final drive.
Caution
♦ Fit the three bolts with spacers at the positions shown
-arrows-.
♦ Use only the correct bolts (same as original equipment) ⇒
Electronic parts catalogue .
– Tighten bolts securing cover for front final drive in two stages
in the sequence shown:
1. Initially hand-tighten bolts in sequence -1 ... 11-.
2. Tighten bolts in sequence -1 ... 11- in several stages to final
torque.
• Tightening torque: 25 Nm.
– Install flange shaft (left-side)
– Install front exhaust pipe (left side) ⇒ Rep. Gr. 26 .
– Install gearbox support (left-side)
– Fill up with gear oil and check gear oil level in front final drive
⇒ page 97 .
Tightening torque
Component
Cover for front final drive to gearbox
Heat shield for drive shaft to gearbox
Bracket for noise insulation to subframe
•
1)
Renew bolts.
multitronic 01J, front-wheel drive - Edition 11.2007
⇒ page 99 .
⇒ page 60 .
Nm
25
23
10
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1)
2. Servicing front final drive
Audi A8 2003 ➤
109