Audi A8 2003 Workshop Manual page 77

– Unscrew ATF drain plug -A- with multi-point bit -3357- and
drain off ATF.
– Tighten ATF drain plug to 24 Nm.
– Unscrew ATF inspection plug -B-.
– Screw connecting piece on stopcock of ATF charging device
for CVT gearboxes -VAS 5162- into threaded hole for ATF in‐
spection plug -B-.
– Turn stopcock in direction of filling hose -lower arrow-. ATF
flows into gearbox.
– Fill gearbox with at least 4.5 to 5 ltr. of fresh ATF.
– Move selector lever to position "P", start engine and allow to
run at idling speed.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Vehicles from model year 2005:
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Shift selector lever to position "P".
– Start engine.
– Rev engine briefly to 2500 rpm.
Caution
The engine must be revved to 2500 rpm to vent air from the
ATF pump after performing repairs on the gearbox.
All models:
– Check and top up ATF level
Note
Observe all notes and test requirements for "Checking ATF level".
multitronic 01J, front-wheel drive - Edition 11.2007
⇒ page 65 .
Audi A8 2003 ➤
9. Checking ATF level and changing ATF
73