Audi A8 2003 Workshop Manual page 52

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
Tightening torques for securing gearbox to engine (illustration
shows gearbox flange)
Item
1, 10, 11
2
3
4, 8
5, 6
7
9
A
• 1)
Renew bolts for securing gearbox to engine.
• 2)
Bolt strength rating 10.9
– Install ATF pipes with new O-rings
– Install front exhaust pipes and align exhaust system so it is
free of stress ⇒ Engine, mechanics; Rep. Gr. 26
– Install gearbox supports and gearbox mountings
⇒ page 60 .
– Bolt drive shafts to flange shafts ⇒ Running gear, front-wheel
drive and four-wheel drive; Rep. Gr. 40 .
– Adjust selector lever cable
– Electrical connections and routing ⇒ Current flow diagrams,
Electrical fault finding and Fitting locations.
– Check oil level in front final drive
– Follow steps required after connecting battery ⇒ Electrical
system; Rep. Gr. 27 .
– After gearbox has been installed, check and top up ATF level
⇒ page 65 .
– Deactivate jacking mode ⇒ Running gear, front-wheel drive
and four-wheel drive; Rep. Gr. 43 ; Adaptive air suspension .
Tightening torques
Component
Bolts/nuts
Except for the following:
Heat shield (left-side) to gearbox
Tunnel cross member to body
Heat shield for drive shaft to gearbox
Front cross member to body
Cross member to subframe
Air duct to throttle valve module -J338-
Body brace to suspension turret
• 1)
Renew nuts.
48
Rep. Gr.37 - Controls, housing
1
Bolt
M10x45
M10x80
M12x100
M12x67
M12x75
M10x90
M10x57
Dowel sleeves for centralising
⇒ page 74 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 33 .
⇒ page 97 .
M6
M8
M10
M12
10
45
Nm
45
2)
65
65
65
65
45
45
Nm
10
20
45
65
23
40
23
23
1)
56