Cleaning Atf Pipes And Atf Cooler - Audi A8 2003 Workshop Manual

1 - Bolt, 9 Nm
2 - Bracket for ATF pipes
3 - ATF pipe
❑ Return pipe from addi‐
tional ATF filter
❑ Tighten union nut to 29
Nm
4 - O-ring
❑ Renew
❑ Lubricate with ATF
when fitting
5 - ATF pipe
❑ Supply pipe to addition‐
al ATF cooler
6 - Bolt, 5 Nm
❑ For securing ATF pipe
to additional ATF cooler
7 - ATF pipe
❑ Supply pipe from gear‐
box to additional ATF
cooler
8 - ATF pipe
❑ Return pipe from addi‐
tional ATF filter to gear‐
box
9 - Bolt, 21 Nm
❑ Secures ATF pipes to
gearbox
❑ First push on ATF pipes
with new O-rings by
hand until they engage.
10 - O-rings
❑ Renew
❑ Lubricate with ATF
when fitting
A - Auxiliary ATF cooler
❑ Removing and installing
⇒ page 78
B - Bracket
❑ For additional ATF filter
and additional ATF cool‐
er
❑ Removing and installing
⇒ page 81
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
C - Additional ATF filter
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Removing and installing
10.2

Cleaning ATF pipes and ATF cooler

Special tools and workshop equipment required
multitronic 01J, front-wheel drive - Edition 11.2007
⇒ page 76
10. Servicing ATF cooling system on vehicles with 3.0 ltr. MPI engine
Audi A8 2003 ➤
75