Cleaning Atf Pipes And Atf Cooler; Removing And Installing Additional Atf Filter - Audi A8 2003 Workshop Manual

12 - Bracket for ATF pipes
13 - Bolt, 9 Nm
14 - Bracket for ATF pipes
15 - Nut, 5 Nm
A - Additional ATF filter
❑ Removing and installing
B - Bracket
❑ For additional ATF filter and additional ATF cooler
❑ Removing and installing
C - Auxiliary ATF cooler
❑ Removing and installing
11.2

Cleaning ATF pipes and ATF cooler

Special tools and workshop equipment required
♦ Used oil collection and extraction unit -V.A.G 1782-
♦ Hose, approx. 18 mm dia.
♦ Compressed air gun (commercially available)
♦ Safety goggles
– Before installing a replacement gearbox, always blow through
the ATF cooler and ATF pipes with compressed air (not more
than 10 bar).
– Also always renew additional ATF filter before installing re‐
placement gearbox.
Note
If the ATF which emerges during cleaning is very dirty, the
♦
pipes and ATF cooler must additionally be flushed out with
clean ATF.
Removing and installing ATF pipes
♦
11.3 Removing and installing additional ATF
filter
Special tools and workshop equipment required
multitronic 01J, front-wheel drive - Edition 11.2007
⇒ page 83
⇒ page 88
⇒ page 85
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 82
11. Servicing ATF cooling system on vehicles with 3.2 ltr. FSI engine and 2.8 ltr. FSI engine
.
Audi A8 2003 ➤
83