Audi A8 2003 Workshop Manual page 39

– Loosen clamping bolt for selector lever cable by approx. 1 turn.
Note
Clamping bolt can only be accessed with selector lever in po‐
♦
sition "D".
Loosen clamping bolt approx. 1 turn – do not remove.
♦
Caution
• After loosening clamping bolt, selector lever must remain
in position "D" for total duration of adjustment process.
– Carefully move selector lever slightly forwards and backwards,
without shifting lever into a different selector lever position.
The selector lever cable is then relieved of stress.
– Check that selector lever is set accurately in position "D". To
do so, push selector lever slightly towards driver's seat and
check selector lever position indicator in instrument cluster.
Caution
• When tightening the clamping bolt, the selector lever must
not be pulled forwards or backwards, as otherwise the
setting will not be accurate.
– Tighten clamping bolt for selector lever cable in this position
(tightening torque: 13 Nm).
Assembly is performed in reverse sequence.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
multitronic 01J, front-wheel drive - Edition 11.2007
Audi A8 2003 ➤
4. Servicing selector mechanism
35