Removing And Installing Tiptronic Switch F189 - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
– Lift off centre console switch panel -arrows-.
– Unplug electrical connectors.
– Release locking hooks -1- on both sides of selector mecha‐
nism -arrow- and lift up cover -3-.
– Unplug electrical connector -2- and remove cover.
Installing
Installation is carried out in reverse sequence; note the following:
– Install selector lever handle
4.4 Removing and installing tiptronic switch
-F189-
Note
The tiptronic switch -F189- is a fixed component of the printed
♦
circuit.
The magnet for the tiptronic switch -F189- is attached to the
♦
sliding cover.
Removing
– Remove selector lever handle
– Remove selector mechanism cover
– Press together middle section of frame -arrows- and simulta‐
neously pull off the cover plate.
18
Rep. Gr.37 - Controls, housing
⇒ page 17 .
⇒ page 17 .
⇒ page 17 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.