Audi A8 2003 Workshop Manual page 44

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
– Pull rubber seal -1- off plenum chamber covers.
– Detach plenum chamber covers -2- and -3-.
– Unscrew rear securing bolts -3- for body brace.
– Secure support bracket -10-222 A- with adapters -10-222 A/
21- and adapter -10-222 A/3- to suspension turrets.
• The adapters -10-222 A/3- point to front.
• Adapters are marked for left and right side of vehicle.
• Centre resting point -2- for adapters is positioned on front bolts
for body brace.
• The adapters -10-222 A/21- are secured with rear securing
bolts -3- for body brace.
• Knurled screw -1- must be tightened far enough to allow sup‐
port plate to rest on suspension turret.
– Hook spindles of support bracket -10-222 A- into front engine
mounting eyes and adapters -10-222 A/3- .
– Lightly pre-tension spindles of support bracket.
– Remove both front wheels.
Note
Secure brake discs with wheel bolts.
– On vehicles fitted with auxiliary heater, remove screws
-arrows- securing exhaust pipe of auxiliary/ additional heater
to noise insulation.
40
Rep. Gr.37 - Controls, housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.