Removing And Installing Additional Atf Cooler - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
– Unscrew 2 bolts -4-.
– Loosen union nut -5- and detach additional ATF filter -C- from
ATF pipe.
– Remove bolt -4-.
– Detach pipe leading to additional ATF filter from additional
ATF cooler -A-.
Installing
Installation is carried out in reverse sequence; note the following:
– Renew O-ring -2-.
– Check ATF level ⇒ page 65
Tightening torques
Component
Additional ATF filter -C- to bracket -B-
2 x bolt -4-
Pipe from additional ATF filter to additional ATF
cooler -A-
1 x bolt -1-
Union nut for ATF pipe to additional ATF filter
10.4 Removing and installing additional ATF
cooler
Special tools and workshop equipment required
78
Rep. Gr.37 - Controls, housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
Nm
5
5
29