Audi A8 2003 Workshop Manual page 71

Display on -VAS 5051 A- :
– From list -1-, select diagnostic function "08 - Read measured
value block".
Display on -VAS 5051 A- :
1 - Enter display group (max. input value = 255).
– Use keypad -2- to enter "10" for "Display group number 10"
and confirm by touching
Display on -VAS 5051 A- :
– Reading for ATF temperature is shown in display zone -3-.
Checking ATF level
– With the brake pedal depressed, shift through all selector lever
positions (P, R, N, D) and hold in each position for approx. 2
sec. at idling speed.
– If applicable, activate jacking mode when raising the vehicle
⇒ Running gear, front-wheel drive and four-wheel drive; Rep.
Gr. 43 ; Adaptive air suspension .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Raise vehicle or drive onto inspection pit.
– On vehicles fitted with auxiliary heater, remove screws
-arrows- securing exhaust pipe of auxiliary/ additional heater
to noise insulation.
multitronic 01J, front-wheel drive - Edition 11.2007
key.
Q
Audi A8 2003 ➤
9. Checking ATF level and changing ATF
67