Audi A8 2003 Workshop Manual page 60

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
– Check that dowel sleeves for centralising engine/gearbox are
in the cylinder block; install if necessary.
– Before installing gearbox, tie electrical wiring off to one side
so that it cannot be trapped between the engine and the gear‐
box.
– Lift gearbox high enough to be able to install selector lever
cable.
Note
Do not bend or kink the selector lever cable.
♦
Before installing, lightly lubricate ball socket on selector lever
♦
cable with polycarbamide grease -G 052 142 A2- .
– Raise gearbox carefully and move to installation position using
gearbox support -T40173- .
– Bolt gearbox onto engine.
Note
Tightening torques apply only to lightly greased, oiled,
♦
phosphated or black-finished nuts and bolts.
♦ Additional lubricant such as engine or gearbox oil may be
used, but do not use graphite lubricant.
Do not use parts which have been degreased.
♦
Tolerance for tightening torques ±15%.
♦
– Raise the gearbox slightly at the rear to install the lower bolts
for securing gearbox to engine.
56
Rep. Gr.37 - Controls, housing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.