Removing And Installing Atf Pipes - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
11 Servicing ATF cooling system on ve‐
hicles with 3.2 ltr. FSI engine and 2.8
ltr. FSI engine
11.1

Removing and installing ATF pipes

Note
Rules for cleanliness when working on the automatic gearbox
♦
⇒ page 9 .
General repair instructions
♦
To install, first press ATF pipes onto gearbox or cooler by hand
♦
until they engage, then bolt on.
Check ATF level after renewing ATF pipes
♦
1 - Bolt, 9 Nm
2 - Bolt, 9 Nm
3 - O-ring
❑ Renew
❑ Lubricate with ATF
when fitting
4 - Bolt, 5 Nm
5 - Union nut, 29 Nm
6 - Bolt, 21 Nm
❑ First push on ATF pipes
with new O-rings by
hand until they engage.
❑ Secures ATF pipes to
gearbox
7 - ATF pipe
❑ Return pipe from addi‐
tional ATF filter to gear‐
box
8 - O-rings
❑ Renew
❑ Lubricate with ATF
when fitting
9 - ATF pipe
❑ Supply pipe from gear‐
box to additional ATF
cooler
10 - ATF pipe
❑ Supply pipe to addition‐
al ATF cooler
11 - ATF pipe
❑ Return pipe from additional ATF filter
82
Rep. Gr.37 - Controls, housing
⇒ page 7 .
⇒ page 65
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.