Audi A8 2003 Workshop Manual page 102

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
– Release quick-release fasteners -1- and -2- and detach noise
insulation panels.
– Place used oil collection and extraction unit -V.A.G 1782- be‐
low gearbox.
WARNING
Wear safety goggles.
– Remove screw plug -arrow-.
– Check the oil level with a suitable improvised tool, e.g. bent
wire.
• Specification: oil level 8.5 mm below bottom lip of oil filler hole.
– Top up gear oil if necessary.
• Gear oil specification
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Note
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
When servicing at the workshop the oil can also be filled up to the
bottom lip of the oil filler hole. However, it will then be necessary
to extract 0.2 litre in order to reach the correct oil level.
– Tighten new screw plug.
Tightening torque
Component
Screw plug to gearbox
•
1)
Renew screw plug.
98
Rep. Gr.39 - Final drive - differential
⇒ page 5 .
Nm
1)
20