Removing And Installing Additional Atf Cooler - Audi A8 2003 Workshop Manual

– Release quick-release fasteners -1- and -2- and detach noise
insulation panels.
– Remove bolts -arrows- and detach ATF cooler with additional
ATF filter (hoses remain connected).
– Place used oil collection and extraction unit -V.A.G 1782- be‐
low ATF cooler.
– Remove bolt -10- and detach ATF pipe from ATF cooler -5-.
– Loosen union nut -12-.
– Remove bolts -2- and detach additional ATF filter -1-.
Installing
Installation is carried out in reverse sequence; note the following:
– Renew O-ring -8-.
– Check ATF level ⇒ page 65
Tightening torques
Component
Additional ATF filter to bracket
Pipe to additional ATF cooler
Union nut for ATF pipe to additional ATF filter
Bracket for additional ATF cooler and additional
ATF filter to body
11.4 Removing and installing additional ATF
cooler
Special tools and workshop equipment required
multitronic 01J, front-wheel drive - Edition 11.2007
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
.
11. Servicing ATF cooling system on vehicles with 3.2 ltr. FSI engine and 2.8 ltr. FSI engine
with respect to the correctness of information in this document. Copyright by AUDI AG.
Nm
9
5
29
9
Audi A8 2003 ➤
85