Checking Ignition Key Removal Lock - Audi A8 2003 Workshop Manual

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
2

Checking ignition key removal lock

WARNING
Prior to performing work with engine running, move selector
lever to position "P" and operate parking brake button to apply
the electronic parking brake.
– Turn the ignition key slightly clockwise to the "ignition on" po‐
sition.
– Press and hold brake pedal.
• When interlock button in selector lever handle is pressed, it
should be possible to move selector lever out of position "P"
without "catching".
– Switch off ignition.
• It should not be possible to remove the ignition key when the
selector lever is in any position other than "P".
– Shift selector lever to position "P".
– Remove ignition key.
• It should only be possible to remove ignition key in selector
lever position "P".
• Selector lever can then not be shifted out of "P" position with
interlock button pressed and brake pedal depressed.
If the ignition key removal lock does not function as described:
– Check entry and start authorisation control unit -J518- in func‐
tion "Guided fault finding" ⇒ Vehicle diagnosis, testing and
information system VAS 5051.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
14
Rep. Gr.37 - Controls, housing