Audi A8 2003 Workshop Manual page 55

– Remove bolts -3 ... 6- (access from above) from engine/gear‐
box flange.
– Pull rubber seal -1- off plenum chamber cover.
– Detach plenum chamber covers -2- and -3-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Unscrew rear securing bolts -3- for body brace.
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Secure support bracket -10-222 A- with adapters -10-222 A/
21- and adapter -10-222 A/3- to suspension turrets.
• The adapters -10-222 A/3- point to front.
• Adapters are marked for left and right side of vehicle.
• Centre resting point -2- for adapters is positioned on front bolts
for body brace.
• The adapters -10-222 A/21- are secured with rear securing
bolts -3- for body brace.
• Knurled screw -1- must be tightened far enough to allow sup‐
port plate to rest on suspension turret.
– Move electrical wires clear at engine lifting eye.
– Hook spindles of support bracket -10-222 A- into front engine
mounting eyes and adapters -10-222 A/3- .
– Lightly pre-tension spindles of support bracket.
– Remove both front wheels.
Note
Secure brake discs with wheel bolts.
multitronic 01J, front-wheel drive - Edition 11.2007
Audi A8 2003 ➤
5. Removing and installing gearbox
51