Audi A8 2003 Workshop Manual page 88

Audi A8 2003 ➤
multitronic 01J, front-wheel drive - Edition 11.2007
♦ Used oil collection and extraction unit -V.A.G 1782-
Removing
Note
♦ Rules for cleanliness when working on the automatic gearbox
⇒ page 9 .
General repair instructions
♦
Before fitting a new gearbox, always blow through the ATF
♦
cooler and ATF pipes with compressed air (not more than
10 bar) ⇒ page 83 and renew the additional ATF filter. If the
ATF which emerges during cleaning is very dirty, the pipes and
ATF cooler must additionally be flushed out with clean ATF.
To install, first press ATF pipes onto gearbox or cooler by hand
♦
until they engage, then bolt on.
– If applicable, activate jacking mode when raising the vehicle
⇒ Running gear, front-wheel drive and four-wheel drive; Rep.
Gr. 43 ; Adaptive air suspension .
– Raise vehicle.
– On vehicles fitted with auxiliary heater, remove screws
-arrows- securing exhaust pipe of auxiliary/ additional heater
to noise insulation.
84
Rep. Gr.37 - Controls, housing
⇒ page 7 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.