Transmission Support With Transmission Mount, Removing And Installing; Transmission Mount, Removing And Installing - Audi Q5 2008 Repair Manual

Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
– Remove the bolts from the tunnel crossmember -arrows-.
– Remove the nuts -arrows- and the tunnel crossmember.
Installing
Install in reverse order of removal. Note the following:
• Tightening specifications. Refer to
⇒ "3.1 Overview - Subframe Mount", page 104
– Install the rear noise insulation. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
3.3 Transmission Support with Transmis‐
sion Mount, Removing and Installing
Removing
– Remove the tunnel crossmember. Refer to
⇒ "3.2 Tunnel Crossmember, Removing and Installing", page
105 .
– Remove the bolts -arrows- and the transmission support with
the transmission mount from the transmission.
Installing
Install in reverse order of removal. Note the following:
• Tightening specifications. Refer to
⇒ "3.1 Overview - Subframe Mount", page 104
– Install tunnel crossmember. Refer to
⇒ "3.2 Tunnel Crossmember, Removing and Installing", page
105 .
3.4 Transmission Mount, Removing and In‐
stalling
Removing
– Remove the transmission support with the transmission
mount. Refer to
⇒ "3.3 Transmission Support with Transmission Mount, Re‐
moving and Installing", page 106
106
Rep. Gr.37 - Controls, Housing
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
.