Setting The Confirm. Feed; Setting The Amount Of Blank Space Between Printed Lines; Setting The Feed Mode Of The Space Of No Data To Be Printed - MIMAKI TS500P-3200 Operation Manual

Setting the Confirm. Feed

Set whether media feeding is performed for checking the
result of the test printing etc. or not.
1
Press the
2
Press to select "Machine Setup"
and press the
3
Press the
4
Press to select "Confirm. Feed"
and press the
5
Press to select ON/ OFF, and
press the
• When you select OFF, proceed to the Step 7.
6
Press to select whether you
perform backward feed after confirm. feed
or not and press the
• Set value : ON/OFF
7
Press the
end the setting.
Setting the amount of blank space
between printed lines
Sets the amount of blank space between printed lines.
1
Press the
2
Press to select "Machine Setup"
and press the
3
Press the
4
Press to select "Spase Btwn PP."
and press the
5
Press to set the amount of blank
space and press the
• Set value : None / 10 to 500mm
6
Press the
end the setting.
(MENU) in Local.
key.
(>>) twice.
key.
key.
key.
key several times to
(MENU) in Local.
key.
(>>) twice.
key.
key.
key several times to
• Back-feed operation is performed when printing
ends if the amount of blank space is set in the
decreasing direction.
Be careful of the following in such cases.
• If media is set in the roll holder without using the
feeding device on the back of the printer, the
media tension of the next printing will change due
to back-feed, possibly causing the feed rate of the
media of only the leading edge of the printed
image to change. In such cases, manually rewind
the media.
• This function is disabled if back-feed after drying
feed is set to OFF in the machine settings
"DRYING FEED" (
• If the printed data already has a blank space,
using this function will result in "Blank space of the
data + Amount of blank space set by using this
function" being output as a blank space.
Setting the feed mode of the space of
no data to be printed
Change the feed mode of the margin included in the
image data (the space of no data to be printed). If print
data with much margin, set to "Continuous", then the print
time can be shorten.
1
Press the
2
Press to select "Machine Setup"
and press the
3
Press the
4
Press to select "Space Feed
Mode" and press the
5
Press to set the feed mode and
press the
• Intermittent : Perform
operation of the path division unit
• Continuous : Feed the no data part at a time
6
Press the
end the setting.
P.3-20).
(MENU) in Local.
key.
(>>) twice.
key.
key.
intermittent feed
key several times to
3
2
2
3-21