Table of Contents
Advertisement
Chapter 3 Setup
Setting Unit (Temperature/ Length)
Units used by this machine are set.
1
Press
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press
3
Press
"UNIT/LENGTH", and press the
key.
4
Press
press the
• Set value of tempture : °C / °F
• Set value of length
5
Press the
end the setting.
Setting a KEY BUZZER
You can turn off the buzzer sound when pressing the key.
1
Press
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press
3
Press
and press the
4
Press
press the
• Set value : ON/ OFF
5
Press the
end the setting.
• When the key buzzer is set to "OFF",
the buzzer sound for errors, warnings,
operation completion, etc. cannot be
shut off.
Setting the VIEW FEED
Set whether media feeding is performed for checking the
result of the test printing etc. or not.
1
Press
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press
3
Press
and press the
3-16
(MENU)
(twice)
(>>) .
to select "UNIT/TEMP." or
to select a set value, and
key.
: mm / inch
key several times to
(MENU)
(twice)
(>>) twice.
to select "KEY BUZZER",
key.
to select a set value, and
key.
key several times to
(MENU)
(twice)
(>>) twice.
to select "VIEW FEED",
key.
4
Press
to select a set value, and
press the
• Set value : ON/ OFF
5
Press the
end the setting.
Setting the space between prints
Set whether media feeding is performed for checking the
result of the test printing etc. or not.
1
Press
(MENU)
in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press
(>>) twice.
3
Press
to select "Space Btwn
PP.", and press the
4
Press
to select a set value, and
press the
• Set value : ON/ OFF
5
Press the
end the setting.
• If you set the direction to reduce the
margin amount, perform backward feed
at the end of printing. In that case, pay
attention to the following points.
• The media tension at the time of the
next print by the backward feed
fluctuates and the feed amount of the
medium may change. In such a case,
rewind the media manually.
• If the data to be printed already has a
margin, using this function will output
"margin attached to data + amount of
margin set by this machine" as margin.
Setting the SPACE FEED MODE
Change the feed mode of the margin included in the
image data (the space of no data to be printed). If print
data with much margin, set to "continuous", then the print
time can be shorten.
1
Press the
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press
(>>) twice.
3
Press
MODE" , and press the
key.
key several times to
(twice)
key.
key.
key several times to
(MENU)
(twice)
to select "SPACE FEED
key.
Advertisement
Table of Contents
