Setting Of The Confirm. Feed; Setting Of The Space Feed Mode; Setting Of The Network - MIMAKI UCJV300-75 Operation Manual

Setting of the CONFIRM. FEED

Set whether media feeding is performed for checking the
result of the test printing etc. or not.
1
In LOCAL mode, press
(twice )
• The MACHINE SETUP MENU appears.
2
Press (>>) once.
3
Press
FEED", and press the
4
Press
press the
• Set Value: ON/ OFF
5
Press the
end the setting.

Setting of the SPACE FEED MODE

Change the feed mode of the margin included in the
image data (the space of no data to be printed). If print
data with much margin, set to "CONTINUOUS", then the
print time can be shorten.
1
In LOCAL mode, press
(twice )
• The MACHINE SETUP MENU appears.
2
Press (>>) twice.
3
Press
MODE", and press the
4
Press to select a setting, Press
the key.
INTERMITTENT: Perform intermittent feed
operation of the path division
unit
CONTINUOUS: Feed the no data part at a time
5
Press the
end the setting.
(MENU)
.
to select "CONFIRM.
key.
to select a setting, and
key.
key several times to
(MENU)
.
to select "SPACE FEED
key.
key several times to
Chapter 3 Machine Setting

Setting of the Network

You can also perform network setting with "Network
Configurator", the tool to perform network setting of
Mimaki's product. To download the Network Configurator,
check " Driver / Utility" on the download page at Mimaki
Engineering (https://mimaki.com/download).
1
In LOCAL mode, press
(twice )
• The MACHINE SETUP MENU appears.
2
Press (>>) twice.
3
Press to select "NETWORK", and
press the
4
Press to select "CHECK IP
ADDRESS", and press the
• The IP address currently used with this machine
is displayed.
• When you have finished the check, press the
[ENTER] key.
• After connecting with the network, it takes time
until the IP address is determined. If the IP
address has not been determined, "0.0.0.0" is
displayed.
5
Press
ADDRESS", and press the
• The MAC address currently used with this
machine is displayed.
• When you have finished the check, press the
[ENTER] key.
6
Press
press the
7
Press
press the
• Set Value: ON/ OFF
• When it is ON, the IP address given by the DHCP
server is used.
8
Press
press the
9
Press
press the
• Set Value: ON/ OFF
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
10
Press to select "IP ADDRESS",
and press the
• Both of DHCP and AutoIP is OFF, you can set IP
Address. For other than above, proceed to the
Step 14.
(MENU)
.
key.
key.
to select "CHECK MAC
key.
to select "DHCP", and
key.
to select a setting, and
key.
to select "AutoIP", and
key.
to select a setting, and
key.
key.
3
2
2
2
3-17