Table of Contents
Advertisement
16. Tighten the 6 mm bolts in sequence to 12 N-m (1.2
kgf-m, 8.7 Ibfft).
NOTE: Whenever any crankshaft or connecting rod
bearing is replaced, it is necessary after
reassembly to run the engine at idling speed until it
reaches normal operating temperature, then
continue to run it for approximately 15 minutes.
@
®
®
®
®
®
®
©
®
®
17. Drive the crankshaft oil seal squarely into the right
side cover.
0 7 7 4 9 - 0 0 1 0 0 0 0
0 7 9 4 8 - S B 0 0 1 0 1
18. Confirm that the clearance is equal all the way
around with a feeler gauge.
Clearance:
0.5 - 0 . 8 mm (0.02-0.03 in.)
19. Clean and dry the right side cover mating surfaces.
Apply a light coat of oil to the crankshaft and to the
lip of the seal.
20. Apply liquid gasket, part No. 08718-0001 or
08718-0003, evenly to the block mating surface of
the right side cover and to the inner threads of the
bolt holes. Install the dowel pins (A) and the right
side cover (B) on the cylinder block.
NOTE: Do not install the parts if 5 minutes or more
have elapsed since applying the liquid gasket.
Instead, reapply liquid gasket after removing the
old residue.
21. After assembly, wait at least 30 minutes before
filling the engine with oil.
(cont'd)
7-33
Advertisement
Table of Contents
Troubleshooting
