Alarm In Setup Screen; Figure 3-19 Ptz Device List - Honeywell HRHD 410 User Manual

Configuration
1.
2.
3.
4.

Alarm In Setup Screen

The alarm terminal strip on the back of the DVR has inputs associated with each alarm.
Use the Alarm In screen to configure each alarm input. Highlight Alarm In in the Device
menu (MENU
displays.
Rev 3.03
To hide the video associated with a camera number, highlight the camera Setup
heading and then press
or select the Setup heading to change the settings for all four cameras at once.
Select from the following options in the drop-down list:
On, Off, Covert 1, Covert 2
Note When you select Covert 1, the DVR displays the camera title and
status icons on the covert video. When you select Covert 2, the
DVR displays only camera title on the covert video.
To assign titles to each camera, highlight the camera title under the Title heading
and then press . A virtual keyboard (see
names.
Selecting the PTZ Device box causes a list of controllable cameras to display.
Select your camera from the list and then press
to the RS485 terminal on the back of the DVR following the camera manufacturer's
instructions.
Figure 3-19
To assign IDs to each camera, highlight the ID heading and then press
change the number, highlight it and use the Up and Down Arrow buttons to
increase and decrease the numbers. The camera ID number can be set from 0 to
256.
➤
Device
. You can select the Setup field for one specific camera
PTZ Device List
➤
Alarm-In) and then press
35
Figure 3-7) allows you to enter camera
. You must connect the camera
. The Alarm In setup screen
Document 900.0315
. To
02/07