Control Of Peripherals By Device Control; External Interface - NF DP Series Instruction Manual

10.26.2 Control of Peripherals by Device Control

You can control DIP.
Set external control function to DevCtrl and connect between CONTROL I/O connector of this
product and CONTROL SIGNAL connector and QUICK CHANGE SYNC INPUT connector of
DIP with the attached cable of DIP. The quick change sync signal is output from this product.
It is not available to use 10.26.1 at the same time.

10.27 External Interface

This is the interface to control the product from an external computer. The RS232 and USB
interfaces are provided by default, and either GPIB or LAN interface can be chosen when ordering.
(Both GPIB and LAN cannot be chosen.)
The command language is compliant with the SCPI Specification Version 1999.0. (Factory default
is USB).
USB interface (USB1.1) *79
Item
Device class
ID
Terminator
*79: The use of USB hub may cause a communication failure. It is recommended to use a
fully-shielded, short cable.
RS232 interface *80 *81
Item
Terminal
Baud rate
Terminator
Parity
Stop bit
Data bit
Flow control
*80: Binary transmission is not supported.
*81: Use a cross cable.
GPIB interface (IEEE488.1 std 1987) *82 *83
Item
Address
Terminator
*82: Binary transmission is not supported.
*83: Query for the main unit status byte using a serial poll is not supported.
LAN interface (IEEE802.3, LXI 1.4 Core 2011) *84
Item
Terminal
Transmission method
Communication protocol
Terminator
IP address setting
*84：Binary transmission is not supported.
DP Series/DP Series Type R
USBTMC
Already assigned for each device
"LF"
Description or Selection
D-sub 9-pin (male, UNC #4-40 screw)
9600 / 19200
"CR" "LF" / "CR" / "LF"
None/Odd/Even
1 / 2
7 / 8
None/Hardware/Software
Description or Selection
0 to 30
"LF"
Description or Selection
RJ-45 modular jack
Ethernet(100BASE-TX / 10BASE-T)
SCPI-RAW
"LF"
Auto, Fixed
10.27 External Interface
Description
Factory default
9600 bps
"CR" "LF"
None
1 bit
8 bit
None
Factory default
2
Factory default
Auto
297