Table of Contents
Advertisement
4. Advanced Operation
2. In the [PwON Output] item, select [2:ON] or [1:OFF]. When you select [ON], the automatic
output-on at power-on is enabled.
4.23
Using the Emission CO
This is the function for calculating and displaying the weight of the carbon dioxide (CO
based on the measured value of the internal loss or the output power of this product. Following two
measuring modes are available: Instantaneous (Unit: kgCO
can change the coefficient for the calculation. For the specification of the emission CO
see 10.11.
-------- Notes ------------------------------------------------------------------------------------------------------------
In the polyphase system, the emission CO
each cabinet.
The emission coefficient (see 4.28) is not restored to the factory default setting even if you
reset this product. To restore the emission coefficient to the factory default setting, follow the
procedure below. For the default setting value, see 10.11.
[DP series Type R only] Instantaneous values are not displayed while the reverse power flow is
operating. Also, integration operation stops.
-----------------------------------------------------------------------------------------------------------------------------
Operation procedure
1. Press the [Measure] soft-key and select [3:CO
206
Calculator
2
/h) and Integration (Unit: tCO
2
of the cabinet is displayed on the LCD panel of
2
View]. The [CO
2
PROGRAMMABLE AC POWER SOURCE
) emission
2
2
View] window opens.
2
). Users
2
calculator,
Advertisement
Table of Contents
