Setting Up A Single Mirage Projector To Display 3D Content; Enabling 3D Mode; Confirming The Emitter Setup - Christie Crimson Series Installation And Setup Manual

Configuration Description
Dual-input 3D In this configuration two video streams are provided by the video server, with the left eye
supplied by one stream and the right eye supplied by the other. The video streams are
frame locked and supplied concurrently.
The dual-input 3D video streams may be supplied by either two Four-Port input video
configurations (such as four cables each supplying one quadrant of the image for each
eye, with a total of eight cables) or two One-Port input video configurations (such as one
cable supplying the entire frame for each eye, with a total of two cables).
Setting up a single Mirage projector to display
3D content
The projector must be installed correctly to display 2D content (optically aligned, focused, and so on)
before completing the following steps to display the 3D content.
1. Enable 3D mode (on page 43).
2. Confirm the emitter setup (on page 43).
3. Configure the projector for the 3D source (on page 44).

Enabling 3D mode

Select the mode for your 3D operation.
1. To enable 3D mode, select MENU > Image Settings > 3D Settings > 3D Mode.
2. Select the appropriate 3D mode:
• Off—Disable the 3D operation.
• Auto Detect—Automatically determine which 3D mode to use based on auxiliary video
data, for example, HDMI info frame.
• Multi-Flash 3D—Display content multiple times to provide a 3D image.

Confirming the emitter setup

Define whether the 3D Sync is output and control how it is processed.
1. To set the 3D output to emitter, select MENU > Image Settings > 3D Settings > 3D Sync
Output.
2. Select To Emitter.
3. Select Enter.
4. To enable the 3D test pattern, select 3D Test Pattern.
5. Select Enter.
6. To configure the dark interval so the amount of dark time aligns with the amount of time
required for the glasses to switch, select Dark Interval.
7. Adjust the slider or enter the dark interval value as required.
8. To confirm your selection, select Enter.
Crimson Installation and Setup Guide–Crimson HD25, Crimson WU25, Crimson HD31, Crimson WU31, Mirage HD25, Mirage WU25
020-102647-07 Rev. 1 (12-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
3D setup for Mirage projectors
43