Required Tools And Components; Lifting And Positioning The Projector; Adjusting The Projector Tilt And Level - Christie CP2415-Xe Installation And Setup Manual

Required tools and components

The following tools and components are required for installation.
• 12" screwdrivers: Phillips #2 (magnetic) and flat
• Wrenches: 19 mm and 7/8"
• Allen keys: 5 mm and other assorted (metric)
• Heat extractor—Required when the projector is operating at 25°C (77°F) at an elevation of 914
meters (3,000 feet) or less.
• Lamp
• Protective safety clothing approved by Christie
• Lens cleaning tissue and solution

Lifting and positioning the projector

Safely lift and position the projector in the location where it will be used.
Warning! If not avoided, the following could result in death or serious injury.
• Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
Position the projector so it is centered and parallel with the theater screen.
If space is limited, aim the projector slightly off-center and use lens offset to center the image
on the screen.

Adjusting the projector tilt and level

Adjust the projector tilt to fill the maximum amount of screen while minimizing keystone. Lens offset
can be used to center the image in the center of the screen.
Warning! If not avoided, the following could result in death or serious injury.
• TIP HAZARD! Always use the rear safety strap to prevent the cinema projector from tipping.
• TIP HAZARD! Do not over-extend the cinema projector's feet. make sure several threads from
each foot remain engaged in the cinema projector's baseplate.
Notice. If not avoided, the following could result in property damage.
• Do not tilt the product more than ±15 degrees.
1. Secure a safety lifting strap rated to handle the projector weight at the rear of the projector.
2. Hoist up the projector.
3. Center the lens parallel with the screen to make sure optimum lens performance with minimal
offset.
If this position is not possible, Christie recommends relying on offset rather than extra tilt.
4. Use a protractor to measure the degree of screen tilt and extend or retract the projector feet
to match this angle.
5. To adjust the vertical or horizontal position of the projector, extend or retract the adjustable
feet on the bottom of the projector (A in the image below).
CP2415-Xe Installation and Setup Guide
020-103584-02 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
18