Chart Settings; Chart Properties - Simrad Maris ECDIS900 Operator's Manual

Chart settings

B
Y DIALOGUE
To load any other ARCS chart, not containing the point clicked on, locate the cursor anywhere
on the chart, click right, locate the cursor on Other Charts, select ARCS and toggle off the
check box Select chart including current point as described in the previous paragraph.
B
Y MOUSE
In chart-by-chart mode, locate the cursor outside the chart and double click. ECDIS scans the
catalogue to find all available charts containing the point where the cursor was located. The
best scale chart is loaded and displayed.
In seamless mode double click on the inactive chart to make it active.
B
Y HOT KEYS OR BUTTONS
Press "+" or "-" to load the chart containing the center of the screen with higher or lower
scale.
Alternatively right click on the zoom in zoom out buttons to achieve the same.
To change the colour scheme, select the relevant item in the colour menu.
Toggle the box Display Chart Borders to highlight the charts available on the hard disk.
NOTE Click on the borderline of the chart displays information about the chart
Toggle the box Display updated tiles borders to highlight the tiles, which have been
updated since the original chart was issued, check on Display updated tiles borders box.
Toggle the box Seamless chart display to switch on the seamless mode.
The ARCS Properties dialogue provides information about the paper chart used to produce
the electronic chart and also provides direct access to the notes included in the paper chart.
The properties dialogue box for an ARCS chart has 2 tabs: General and Technical.
64
C
HART SETTINGS
C
HART PROPERTIES