Cursor Bearings; Applying Default Control Settings - Simrad R2009 User Manual

You can select to show target vectors with true or relative speed, and you can set the length
of the vector. The length represents the vessel movement within the given time period.
Vector settings are shown in the Target indicators panel (A).
Note:
True speed indication is not possible if there is a Gyro or Speed source failure. If the
vectors are in true presentation and one of the sensors (gyro or speed log) fails, the
presentation is automatically switched to relative.

Cursor bearings

You can select to show the cursor bearings as True or Relative to own vessel.
Note:
True can only be selected when a gyro is available.

Applying default control settings

The default control settings allows for quickly setting the system back to a known state.
The default parameters are:
Function
Vector
Target trails
Collision warning
VRM EBL
Range
Range rings
Orientation
Motion mode
Off-centering
Speed source
Past position
AIS
Radar view options | R2009/R3016 User manual
Default setting
Mode - relative; time - 6 min
Mode - relative; time - 6 min
CPA - 2 NM; TCPA - 12 min
One EBL/VRM, EBL - 0.25 NM; VRM - 0
6 NM
Off
North up
True
Look ahead
EPFS; Stabilization - Ground
Off
On
23