Simrad Maris ECDIS900 Operator's Manual page 57

Install charts
I
MPORTANT
At any time, up to ten per cent of the charts on an area CD may have been replaced by New
Editions contained on the latest Update CD. Users should always install relevant New Edition
charts from the Update CD before applying the Updates. The update CD contains the latest
ARCS chart catalogue plus cumulative updates for all charts in the catalogue. Each Area CD
and Update CD has the date on the label. Only the latest CD of either type should be retained
on board and used with the system.
I
NSTALL SELECTED CHARTS
Click the Install selected charts button and the system will list all charts on the CD-ROM along
with the parameters: Number, Scale, Permits, Status and Name.
Make a selection, using standard windows procedures, and press Install.
CTRL +
Click CTRL + "Install selected charts" button to select CD in a shared drive in the LAN.
The charts with a valid installed permit are displayed with a green spot in the left hand
column. If the permit is not valid the spot is red. Select the chart or charts to be installed and
then click the button Install charts. The charts are copied onto the hard disk.
The list of charts can be sorted, either ascending or descending, by each parameter. By
default, charts with a valid permit are displayed on the top of the list.
To perform a sort, click on the column headings. Alternative clicks will sort ascending and
then descending.
I
MPORTANT
The user may install charts with without permits (or with invalid permits) and then install
permits later. It is recommended that if sufficient disk space is available, the user installs all
the charts in the trading area and only purchases the chart permits needed. Chart permits for
charts not normally used or covering routes to ports of refuge or diversion can be ordered by
57 phone, fax or email with immediate response in an emergency.