Edge-Core ECS3510-10PD Management Manual page 576

| IP Configuration
C 15
HAPTER
Setting the Switch's IP Address (IP Version 4)
IP will not function until a reply has been received from the server.
Requests will be broadcast periodically by the switch for an IP address.
DHCP/BOOTP responses can include the IP address, subnet mask, and
default gateway. (Default: DHCP)
IP Address Type – Specifies a primary or secondary IP address. An
◆
interface can have only one primary IP address, but can have many
secondary IP addresses. In other words, secondary addresses need to
be specified if more than one IP subnet can be accessed through this
interface. For initial configuration, set this parameter to Primary.
(Options: Primary, Secondary; Default: Primary)
Note that a secondary address cannot be configured prior to setting the
primary IP address, and the primary address cannot be removed if a
secondary address is still present. Also, if any router or switch in a
network segment uses a secondary address, all other routers/switches
in that segment must also use a secondary address from the same
network or subnet address space.
IP Address – Address of the VLAN to which the management station is
◆
attached. Valid IP addresses consist of four numbers, 0 to 255,
separated by periods. (Default: None)
Subnet Mask – This mask identifies the host address bits used for
◆
routing to specific subnets. (Default: None)
Restart DHCP – Requests a new IP address from the DHCP server.
◆
W I
EB NTERFACE
To set a static IPv4 address for the switch:
Click System, IP.
1.
Select Configure Interface from the Step list.
2.
Select Add Address from the Action list.
3.
Select the VLAN through which the management station is attached,
4.
set the IP Address Mode to "User Specified," specify a primary or
secondary address type, then enter the IP address and subnet mask.
– 576 –