Edge-Core ECS3510-10PD Management Manual page 216

| VLAN Configuration
C 6
HAPTER
IEEE 802.1Q Tunneling
based on the indicated priority and appropriate methods of queue
management at intermediate nodes across the tunnel.
Rather than relying on standard service paths and priority queuing,
◆
QinQ VLAN mapping can be used to further enhance service by defining
a set of differentiated service pathways to follow across the service
provider's network for traffic arriving from specified inbound customer
VLANs.
◆ Note that all customer interfaces should be configured as access
interfaces (that is, a user-to-network interface) and service provider
interfaces as uplink interfaces (that is, a network-to-network interface).
Use the Configure Interface page described in the next section to set an
interface to access or uplink mode.
P
ARAMETERS
These parameters are displayed:
Port – Port identifier. (Range: 1-10)
◆
Customer VLAN ID – VLAN ID for the inner VLAN tag.
◆
(Range: 1-4094)
Service VLAN ID – VLAN ID for the outer VLAN tag. (Range: 1-4094)
◆
W I
EB NTERFACE
To configure a mapping entry:
Click VLAN, Tunnel.
1.
Select Configure Service from the Step list.
2.
Select Add from the Action list.
3.
Select an interface from the Port list.
4.
Specify the CVID to SVID mapping for packets exiting the specified
5.
port.
Click Apply.
6.
Figure 81: Configuring CVLAN to SPVLAN Mapping Entries
– 216 –