Edge-Core ECS3510-10PD Management Manual page 430

| Basic Administration Protocols
C 14
HAPTER
Configuring Event Logging
P
ARAMETERS
These parameters are displayed:
SMTP Status – Enables/disables the SMTP function. (Default: Enabled)
◆
Severity – Sets the syslog severity threshold level (see table on
◆
page 426) used to trigger alert messages. All events at this level or
higher will be sent to the configured email recipients. For example,
using Level 7 will report all events from level 7 to level 0.
(Default: Level 7)
Email Source Address – Sets the email address used for the "From"
◆
field in alert messages. You may use a symbolic email address that
identifies the switch, or the address of an administrator responsible for
the switch.
Email Destination Address – Specifies the email recipients of alert
◆
messages. You can specify up to five recipients.
Server IP Address – Specifies a list of up to three recipient SMTP
◆
servers. IPv4 or IPv6 addresses may be specified. The switch attempts
to connect to the listed servers in sequential order if the first server
fails to respond.
W I
EB NTERFACE
To configure SMTP alert messages:
Click Administration, Log, SMTP.
1.
Enable SMTP, specify a source email address, and select the minimum
2.
severity level. Specify the source and destination email addresses, and
one or more SMTP servers.
Click Apply.
3.
– 430 –