Edge-Core ECS3510-10PD Management Manual page 502

| Basic Administration Protocols
C 14
HAPTER
Ethernet Ring Protection Switching
ERPS R
ING
C
ONFIGURATION
Figure 287: Setting ERPS Global Status
Use the Administration > ERPS (Configure Domain) pages to configure
ERPS rings.
CLI R
EFERENCES
"ERPS Commands" on page 1099
◆
C U
OMMAND SAGE
Ring Initialization
An ERPS ring containing one Control VLAN and one or more protected Data
VLANs must be configured, and the global ERPS function enabled on the
switch (see "ERPS Global Configuration" on page
start running. Once enabled, the RPL owner node and non-owner node
state machines will start, and the ring will enter the active state.
Limitations
When configuring a ring port, note that these ports cannot be part of a
spanning tree, nor can they be members of a static or dynamic trunk.
P
ARAMETERS
These parameters are displayed:
Add
Domain Name – Name of an ERPS ring. (Range: 1-12 characters)
◆
Domain ID – ERPS ring identifier used in R-APS messages.
◆
(Range: 1-255)
Show
Domain Name – Name of a configured ERPS ring.
◆
ID – ERPS ring identifier used in R-APS messages.
◆
Admin Status – Shows whether ERPS is enabled on the switch.
◆
Ver – Shows the ERPS version.
◆
MEG Level – The maintenance entity group (MEG) level providing a
◆
communication channel for ring automatic protection switching (R-APS)
information.
– 502 –
501) before a ring can