Specifying Static Interfaces For An Ipv6 Multicast Router - Edge-Core ECS3510-10PD Management Manual

| Multicast Filtering
C 17
HAPTER
MLD Snooping (Snooping and Query for IPv6)
S S
PECIFYING TATIC
I
NTERFACES FOR AN
IP 6 M
V ULTICAST
R
OUTER
Figure 379: Configuring Immediate Leave for MLD Snooping
Use the Multicast > MLD Snooping > Multicast Router (Add Static Multicast
Router) page to statically attach an interface to an IPv6 multicast router/
switch.
Depending on your network connections, MLD snooping may not always be
able to locate the MLD querier. Therefore, if the MLD querier is a known
multicast router/switch connected over the network to an interface (port or
trunk) on the switch, you can manually configure that interface to join all
the current multicast groups.
CLI R
EFERENCES
◆ "ipv6 mld snooping vlan mrouter" on page 1247
C U
OMMAND SAGE
MLD Snooping must be enabled globally on the switch (see
MLD Snooping and Query Parameters" on page
router port can take effect.
P
ARAMETERS
These parameters are displayed:
VLAN – Selects the VLAN which is to propagate all IPv6 multicast traffic
◆
coming from the attached multicast router. (Range: 1-4094)
◆ Interface – Activates the Port or Trunk scroll down list.
Port or Trunk – Specifies the interface attached to a multicast router.
◆
W I
EB NTERFACE
To specify a static interface attached to a multicast router:
Click Multicast, MLD Snooping, Multicast Router.
1.
Select Add Static Multicast Router from the Action list.
2.
Select the VLAN which will forward all the corresponding IPv6 multicast
3.
traffic, and select the port or trunk attached to the multicast router.
Click Apply.
4.
– 646 –
"Configuring
643) before a multicast