Network-Access Mac-Filter - Edge-Core ECS3510-10PD Management Manual

◆
E
XAMPLE
Console(config-if)#network-access aging
Console(config-if)#
Use this command to add a MAC address into a filter table. Use the no
network-access
form of this command to remove the specified MAC address.
mac-filter
S
YNTAX
D
EFAULT
Disabled
C
OMMAND
Global Configuration
C
OMMAND
◆
◆
◆
◆
E
XAMPLE
Console(config)#network-access mac-filter 1 mac-address 11-22-33-44-55-66
Console(config)#
regardless of the 802.1X Operation Mode (Single-Host, Multi-Host, or
MAC-Based authentication as described on
The maximum number of secure MAC addresses supported for the
switch system is 1024.
[no] network-access mac-filter filter-id
mac-address mac-address [mask mask-address]
filter-id - Specifies a MAC address filter table. (Range: 1-64)
mac-address - Specifies a MAC address entry.
(Format: xx-xx-xx-xx-xx-xx)
mask - Specifies a MAC address bit mask for a range of addresses.
S
ETTING
M
ODE
U
SAGE
Specified addresses are exempt from network access authentication.
This command is different from configuring static addresses with the
mac-address-table static
range of addresses when using a mask, and then to assign these
addresses to one or more ports with the
command.
Up to 64 filter tables can be defined.
There is no limitation on the number of entries that can entered in a
filter table.
– 887 –
| General Security Measures
C 24
HAPTER
Network Access (MAC Address Authentication)
page
command in that it allows you configure a
network-access port-mac-filter
858).