Displaying Local Mips; Displaying Remote Meps - Edge-Core ECS3510-10PD Management Manual

Use the Administration > CFM > Show Information (Show Local MIP) page
D
ISPLAYING
to show the MIPs on this device discovered by the CFM protocol. (For a
L MIP
OCAL S
description of MIPs, refer to the Command Usage section under
"Configuring CFM Maintenance
CLI R
EFERENCES
"show ethernet cfm maintenance-points local" on page 1342
◆
P
ARAMETERS
These parameters are displayed:
MD Name – Maintenance domain name.
◆
Level – Authorized maintenance level for this domain.
◆
MA Name – Maintenance association name.
◆
◆ Primary VLAN – Service VLAN ID.
Interface – Physical interface of this entry (either a port or trunk).
◆
W I
EB NTERFACE
To show information for the MIPs discovered by the CFM protocol:
Click Administration, CFM.
1.
Select Show Information from the Step list.
2.
Select Show Local MIP from the Action list.
3.
Figure 313: Showing Information on Local MIPs
Use the Administration > CFM > Show Information (Show Remote MEP)
D
ISPLAYING
page to show MEPs located on other devices which have been discovered
R MEP
EMOTE S
through continuity check messages, or statically configured in the MEP
database and verified through cross-check messages.
CLI R
EFERENCES
"show ethernet cfm maintenance-points remote detail" on page 1345
◆
"clear ethernet cfm maintenance-points remote" on page 1350
◆
C 14
HAPTER
Domains".)
– 551 –
| Basic Administration Protocols
Connectivity Fault Management