Edge-Core ECS3510-10PD Management Manual page 176

| Interface Configuration
C 5
HAPTER
Trunk Configuration
To add member ports to a static trunk:
Click Interface, Trunk, Static.
1.
Select Configure Trunk from the Step list.
2.
Select Add Member from the Action list.
3.
Select a trunk identifier.
4.
Set the unit and port for an additional trunk member.
5.
Click Apply.
6.
Figure 47: Adding Static Trunks Members
To configure connection parameters for a static trunk:
Click Interface, Trunk, Static.
1.
Select Configure General from the Step list.
2.
Select Configure from the Action list.
3.
Modify the required interface settings. (Refer to
4.
List" on page 152 for a description of the parameters.)
Click Apply.
5.
Figure 48: Configuring Connection Parameters for a Static Trunk
– 176 –
"Configuring by Port