Edge-Core ECS3510-10PD Management Manual page 462

| Basic Administration Protocols
C 14
HAPTER
Simple Network Management Protocol
C
ONFIGURING
SNMP 3 G
V ROUPS
To show the OID branches configured for the SNMP views of the switch's
MIB database:
Click Administration, SNMP.
1.
Select Configure View from the Step list.
2.
Select Show OID Subtree from the Action list.
3.
Select a view name from the list of existing views.
4.
Figure 254: Showing the OID Subtree Configured for SNMP Views
Use the Administration > SNMP (Configure Group) page to add an SNMPv3
group which can be used to set the access policy for its assigned users,
restricting them to specific read, write, and notify views. You can use the
pre-defined default groups or create new groups to map a set of SNMP
users to SNMP views.
CLI R
EFERENCES
"show snmp group" on page 800
◆
P
ARAMETERS
These parameters are displayed:
◆ Group Name – The name of the SNMP group to which the user is
assigned. (Range: 1-32 characters)
Security Model – The user security model; SNMP v1, v2c or v3.
◆
Security Level – The following security levels are only used for the
◆
groups assigned to the SNMP security model:
noAuthNoPriv – There is no authentication or encryption used in
■
SNMP communications. (This is the default security level.)
AuthNoPriv – SNMP communications use authentication, but the
■
data is not encrypted.
AuthPriv – SNMP communications use both authentication and
■
encryption.
– 462 –