Edge-Core ECS3510-10PD Management Manual page 445

integer value derived from the list position of the corresponding
dot3MauType as listed in IETF RFC 3636 and is equal to the last number
in the respective dot3MauType OID.
Port Details – 802.3 Extension Power Information
Remote Power Class – The port Class of the given port associated
◆
with the remote system (PSE – Power Sourcing Equipment or PD –
Powered Device).
Remote Power MDI Status – Shows whether MDI power is enabled
◆
on the given port associated with the remote system.
Remote Power Pairs – "Signal" means that the signal pairs only are
◆
in use, and "Spare" means that the spare pairs only are in use.
Remote Power MDI Supported – Shows whether MDI power is
◆
supported on the given port associated with the remote system.
Remote Power Pair Controllable – Indicates whether the pair
◆
selection can be controlled for sourcing power on the given port
associated with the remote system.
◆ Remote Power Classification – This classification is used to tag
different terminals on the Power over LAN network according to their
power consumption. Devices such as IP telephones, WLAN access
points and others, will be classified according to their power
requirements.
Port Details – 802.3 Extension Trunk Information
◆ Remote Link Aggregation Capable – Shows if the remote port is not
in link aggregation state and/or it does not support link aggregation.
Remote Link Aggregation Status – The current aggregation status
◆
of the link.
Remote Link Port ID – This object contains the IEEE 802.3
◆
aggregated port identifier, aAggPortID (IEEE 802.3-2002, 30.7.2.1.1),
derived from the ifNumber of the ifIndex for the port component
associated with the remote system. If the remote port is not in link
aggregation state and/or it does not support link aggregation, this
value should be zero.
Port Details – 802.3 Extension Frame Information
Remote Max Frame Size – An integer value indicating the maximum
◆
supported frame size in octets on the port component associated with
the remote system.
Port Details – LLDP-MED Capability
◆ Device Class – Any of the following categories of endpoint devices:
Class 1 – The most basic class of endpoint devices.
■
– 445 –
| Basic Administration Protocols
C 14
HAPTER
Link Layer Discovery Protocol
7