Configuring Mac Address Mirroring - Edge-Core ECS3510-10PD Management Manual

C MAC A
ONFIGURING
W I
EB NTERFACE
To clear the entries in the dynamic address table:
Click MAC Address, Dynamic.
1.
Select Clear Dynamic MAC from the Action list.
2.
Select the method by which to clear the entries (i.e., All, MAC Address,
3.
VLAN, or Interface).
Enter information in the additional fields required for clearing entries by
4.
MAC Address, VLAN, or Interface.
Click Clear.
5.
Figure 99: Clearing Entries in the Dynamic MAC Address Table
M
DDRESS IRRORING
Use the MAC Address > Mirror (Add) page to mirror traffic matching a
specified source address from any port on the switch to a target port for
real-time analysis. You can then attach a logic analyzer or RMON probe to
the target port and study the traffic crossing the source port in a
completely unobtrusive manner.
CLI R
EFERENCES
◆ "Local Port Mirroring Commands" on page 1023
C U
OMMAND SAGE
When mirroring traffic from a MAC address, ingress traffic with the
◆
specified source address entering any port in the switch, other than the
target port, will be mirrored to the destination port.
All mirror sessions must share the same destination port.
◆
Spanning Tree BPDU packets are not mirrored to the target port.
◆
When mirroring port traffic, the target port must be included in the
◆
same VLAN as the source port when using MSTP (see
Algorithm" on page
When mirroring VLAN traffic (see
◆
page 227) or packets based on a source MAC address, the target port
– 235 –
C
HAPTER

Configuring MAC Address Mirroring

239).
"Configuring VLAN Mirroring" on
| Address Table Settings
7
"Spanning Tree