Showing The Ipv6 Neighbor Cache; Table 38: Show Ipv6 Neighbors - Display Description - Edge-Core ECS3510-10PD Management Manual

| IP Configuration
C 15
HAPTER
Setting the Switch's IP Address (IP Version 6)
S IP 6
HOWING THE V
N C
EIGHBOR ACHE
Note that the solicited-node multicast address (link-local scope FF02) is
used to resolve the MAC addresses for neighbor nodes since IPv6 does
not support the broadcast method used by the Address Resolution
Protocol in IPv4.
These additional addresses are displayed by the CLI (see
interface" on page 1407).
Configuration Mode – Indicates if this address was automatically
◆
generated for manually configured.
W I
EB NTERFACE
To show the configured IPv6 addresses:
Click IP, IPv6 Configuration.
1.
Select Show IPv6 Address from the Action list.
2.
Select a VLAN from the list.
3.
Figure 337: Showing Configured IPv6 Addresses
Use the IP > IPv6 Configuration (Show IPv6 Neighbor Cache) page to
display the IPv6 addresses detected for neighbor devices.
CLI R
EFERENCES
"show ipv6 neighbors" on page 1437
◆
P
ARAMETERS
These parameters are displayed:

Table 38: Show IPv6 Neighbors - display description

Field Description
IPv6 Address IPv6 address of neighbor
Age The time since the address was verified as reachable (in seconds). A static
entry is indicated by the value "Permanent."
Link-layer Addr Physical layer MAC address.
– 588 –
"show ip