Edge-Core ECS3510-10PD Management Manual page 954

| General Security Measures
C 24
HAPTER
Port-based Traffic Segmentation
traffic-segmentation
uplink/downlink
D S
EFAULT ETTING
None
C M
OMMAND ODE
Global Configuration
Command Usage
◆ Use this command to create a new traffic-segmentation client session.
Using the no form of this command will remove any assigned uplink or
◆
downlink ports, restoring these interfaces to normal operating mode.
Example
Console(config)#traffic-segmentation session 1
Console(config)#
This command configures the uplink and down-link ports for a segmented
group of ports. Use the no form to remove a port from the segmented
group.
S
YNTAX
[no] traffic-segmentation [session session-id] {uplink interface-list
[downlink interface-list] | downlink interface-list}
session-id – Traffic segmentation session. (Range: 1-4)
uplink – Specifies an uplink interface.
downlink – Specifies a downlink interface.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
D S
EFAULT ETTING
Session 1 if not defined
No segmented port groups are defined.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
A port cannot be configured in both an uplink and downlink list.
◆
A port can only be assigned to one traffic-segmentation session.
◆
– 954 –