Edge-Core ECS3510-10PD Management Manual page 865

A port cannot be configured as a dot1x supplicant if it is a member of a
◆
trunk or LACP is enabled on the port.
E
XAMPLE
Console(config)#interface ethernet 1/2
Console(config-if)#dot1x pae supplicant
Console(config-if)#
This command sets the time that a supplicant port waits for a response
dot1x timeout
from the authenticator. Use the no form to restore the default setting.
auth-period
S
YNTAX
dot1x timeout auth-period seconds
no dot1x timeout auth-period
D
EFAULT
30 seconds
C
OMMAND
Interface Configuration
C
OMMAND
This command sets the time that the supplicant waits for a response from
the authenticator for packets other than EAPOL-Start.
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout auth-period 60
Console(config-if)#
This command sets the time that a supplicant port waits before resending
dot1x timeout
its credentials to find a new an authenticator. Use the no form to reset the
held-period
default.
S
YNTAX
dot1x timeout held-period seconds
no dot1x timeout held-period
D
EFAULT
60 seconds
seconds - The number of seconds. (Range: 1-65535)
M
ODE
U
SAGE
seconds - The number of seconds. (Range: 1-65535)
– 865 –
| Authentication Commands
C 23
HAPTER
802.1X Port Authentication