Saving The Running Configuration To A Local File - Edge-Core ECS3510-10PD Management Manual

| Basic Management Tasks
C 4
HAPTER
Managing System Files
S R
AVING THE UNNING
C
ONFIGURATION TO A
L F
OCAL ILE
If FTP Upload is used, enter the user name and password for your
5.
account on the FTP server.
Set the file type to Operation Code.
6.
Enter the name of the file to download.
7.
Select a file on the switch to overwrite or specify a new file name.
8.
Then click Apply.
9.
Figure 7: Copy Firmware
If you replaced a file currently used for startup and want to start using the
new file, reboot the system via the System > Reset menu.
Use the System > File (Copy) page to save the current configuration
settings to a local file on the switch. The configuration settings are not
automatically saved by the system for subsequent use when the switch is
rebooted. You must save these settings to the current startup file, or to
another file which can be subsequently set as the startup file.
CLI R
EFERENCES
"copy" on page 728
◆
P
ARAMETERS
The following parameters are displayed:
Copy Type – The copy operation includes this option:
◆
Running-Config – Copies the current configuration settings to a local
■
file on the switch.
◆ Destination File Name – Copy to the currently designated startup
file, or to a new file. The file name should not contain slashes (\ or /),
the leading letter of the file name should not be a period (.), and the
maximum length for file names is 32 characters for files on the switch.
(Valid characters: A-Z, a-z, 0-9, ".", "-", "_")
– 126 –